Datasheet Texas Instruments 5962-9958301QPA

ManufacturerTexas Instruments
SeriesTL5001M
Part Number5962-9958301QPA
Datasheet Texas Instruments 5962-9958301QPA

PWM Controller with Wide Input Range 8-CDIP -55 to 125

Datasheets

Pulse-Width-Modulation Control Circuits datasheet
PDF, 1.1 Mb, Revision: F, File published: Jan 31, 2002
Extract from the document

Prices

Status

Lifecycle StatusActive (Recommended for new designs)
Manufacture's Sample AvailabilityNo

Packaging

Pin88
Package TypeJGJG
Industry STD TermCDIPCDIP
JEDEC CodeR-GDIP-TR-GDIP-T
Package QTY11
CarrierTUBETUBE
Device MarkingTL5001M9958301QPA
Width (mm)6.676.67
Length (mm)9.69.6
Thickness (mm)4.574.57
Pitch (mm)2.542.54
Max Height (mm)5.085.08
Mechanical DataDownloadDownload

Parametrics

Duty Cycle(Max)100 %
Iout(Max)3 A
Iq(Typ)1.1 mA
Operating Temperature Range-55 to 125 C
Package GroupCDIP
RatingMilitary
Regulated Outputs1
Switching Frequency(Max)400 kHz
Switching Frequency(Min)50 kHz
TypeController
Vin(Max)40 V
Vin(Min)3.6 V
Vout(Max)50 V
Vout(Min)1 V

Eco Plan

RoHSSee ti.com

Application Notes

  • Examples Of Applications With The Pulse Width Modulator TL5001
    PDF, 462 Kb, File published: Jan 1, 1997
    Switched-mode techniques are used more and more nowadays for the design of power supplies. Switch mode power supplies have considerably higher efficiency when compared to designs employing linear regulators, and can be used for higher output powers. The rectified input voltage in a switching regulator is chopped by means of a switch. The LC network after the switch smoothes this voltage, resulting
  • Understanding Buck Power Stages In Switchmode Power Supplies
    PDF, 173 Kb, File published: Mar 4, 1999
    A switching power supply consists of the power stage and the control circuit. The power stage performs the basic power conversion from the input voltage to the output voltage and includes switches and the output filter. This report addresses the buck power stage only and does not cover control circuits. Detailed steady-state and small-signal analysis of the buck power stage operating in continuous
  • Off-Line SMPS Failure Modes PWM Switchers and DC-DC Converters
    PDF, 71 Kb, File published: Mar 22, 2000
    Today's voltage regulator modules (VRMs) employ off-line SMPS techniques. Traditionally, they are usually discarded when they fail because they are so challenging to debug and so inexpensive to replace. Investigation of these failed modules reveals some common failure modes. Some failures are caused by other systems' passive components that fail after repeated electrical stress. Recognizing these
  • Understanding Buck-Boost Power Stages in Switchmode Power Supplies (Rev. A)
    PDF, 363 Kb, Revision: A, File published: May 28, 2002
  • Understanding Boost Power Stages In Switchmode Power Supplies
    PDF, 149 Kb, File published: Mar 4, 1999
    A switching power supply consists of the power stage and the control circuit. The power stage performs the basic power conversion from the input voltage to the output voltage and includes switches and the output filter. This report addresses the boost power stage only and does not cover control circuits. The report includes detailed steady-stage and small-signal analysis of the boost power stage o
  • Designing with the TL5001 PWM Controller (Rev. A)
    PDF, 265 Kb, Revision: A, File published: Sep 1, 1995
    Electrical and electronic products required to be lighter, smaller, use less power, and cost less. Manufacturers are turning to small high-frequency dc-to-dc converters for the power supply solution. The TL5001, pulse-width modulator (PWM) control integrated circuit, when combined with a few external components, can implement the converters and operate at frequencies to 400 kHz. This document p

Model Line

Series: TL5001M (3)

Manufacturer's Classification

  • Semiconductors > Space & High Reliability > Power Management Products > Non-isolated DC/DC Switching Regulators

Other Names:

59629958301QPA, 5962 9958301QPA

EMS supplier