In-circuit debugger and programmer Atmel JTAGICE3

Mid-range in-circuit debugger and programmer for Atmel 8-bit and 32-bit AVR microcontrollers with on-chip debugging for source level symbolic debugging, NanoTrace (if supported by the device) and device programming.

Detailed Description

Atmel: in-circuit debugger and programmer JTAGICE3

JTAGICE3 supports the following programming modes:

  • SPI
  • JTAG
  • PDI
  • aWire

It also supports debugging using the following interfaces:

  • debugWIRE
  • JTAG
  • PDI
  • aWire

Features:

  • Supports a large number of AVR devices
  • Supports up to 3 hardware program breakpoints or 1 maskable data breakpoint (depending on the OCD module on the AVR device)
  • Supports symbolic debug of complex data types including scope information.
  • Supports up to 128 software breakpoints
  • Level converters support 1.8V to 5.5V target operation
  • Uploads 256Kb code in ~ 15 seconds (XMEGA using JTAG interface)
  • Hi-Speed USB connection to host PC Firmware upgradeable for supporting future AVR devices
  • Supports NanoTrace (depending on the OCD module on the AVR device; uses target device's memory)
  • USB powered.

JTAGICE3 is supported by AVR Studio 5.

What's in the Box

  • JTAGICE3 unit
  • USB High Speed cable ~1.5m
  • 50-mil squid cable
  • 50-mil IDC cable
  • Adapter kit consisting of 10-pin 100 mil, 6-pin 100 mil, and 6-pin 50 mil

atmel.com

You may have to register before you can post comments and get full access to forum.
EMS supplier