In-circuit Programmer and debugger Cypress CY8CKIT-002

CY8CKIT-002 PSoC MiniProg3 Program and Debug Kit

Detailed Description

The PSoC MiniProg3 Program and Debug Kit is an all-in-one programmer for PSoC 1, PSoC 3 and PSoC 5 architectures, debug tool for PSoC 3 and PSoC 5 architectures, and a USB-I2C Bridge for debugging I2C serial connections and communicating to PSoC devices.

The Miniprog3 supports the following protocols:

  • SWD
  • JTAG
  • ISSP
  • USB-I2C

Included with the kit is a 10-pin ribbon cable for connecting to standard 10-pin JTAG header interfaces utilized for our PSoC 3 and PSoC 5 architectures while the device itself supports the 5-pin ISSP programming header for PSoC 1 architectures.

The 5-pin connector also supports the USB-I2C Bridging capabilities and is a superset of the CY3240 capabilities. Please note, the CY8CKIT-002 only contains the Miniprog3 and supporting cables.

In-circuit Programmer and debugger Cypress CY8CKIT-002

Cypress Semiconductor has completed a hardware update to the Miniprog3 to address hardware issues seen with programming, ESD, and power management. The Miniprog3 revision, either *A or *B, is indicated using sticker on the back of the programmer. The following are a list of updates made to the Miniprog3 *B programmer.

  • Updated Hardware to Improve Power Cycle Programming:

The Miniprog3 hardware has been updated to better improve power cycle programming for all PSoC devices. It was discovered that the Miniprog3 *A programmer revision did not correctly implement the power cycle programming methodology. Due to this issue the Miniprog3 *A programmer could not correctly support power cycle programming for PSoC 3 and PSoC 5 devices. This specifically impacts customers who do not route out the XRES line to the programming connector or disable the optional XRES line on certain devices. The *B revision of the Miniprog3 will support power cycle programming for all PSoC 3 and PSoC 5 devices.

  • Over-current and Non-Polarized Connection Updates:

There are known electrical risks to the Miniprog3 *A revision that have been addressed with the *B update. To address the electrical issues the Miniprog3 *B programmer has added ESD over-current protection to the USB lines and has added electrical protection to the 5 and 10-pin connectors in case of a reverse polarity condition.

  • Improved Voltage Detection Capabilities:

The Miniprog3 *B programmer has been updated to improve the voltage detection capabilities. The Miniprog3 will measure the target voltage within an accuracy of 20 mV for a range of 1.8V – 5.0V.

  • Supported Software:

The Miniprog3 *B programmer is supported on the latest release of PSoC Programmer.

CY8CKIT-002 Contents

  • MiniProg3 programmer/debugger
  • 10-pin ribbon cable
  • USB cable
  • Software CD
  • Quick start guide

cypress.com
 

Other Names:

CY8CKIT002, CY8CKIT 002

You may have to register before you can post comments and get full access to forum.
EMS supplier