Evaluation kit Texas Instruments ANTC7EK1

CC257x single-mode ANT network processor and evaluation kit

Detailed Description

TI's CC257x ANT is a dual-chip sensor solution, combining the 2.4-GHz CC257x network processor and an MSP430™ microcontroller.

The CC257x network processors are 2.4 GHz devices tailored for ANT sensor applications. The CC257x evaluation kit (ANTC7EK1) contains everything needed to quickly explore and develop with the CC257x, including the integrated ANT-FS feature.

Texas Instruments: ANTC7EK1 Evaluation Kit

Includes latest version of the proven ANT protocol stack, including features such as

  • High density node support – up to 300 nodes at 1 Hz Tx rate in same RF space
  • Frequency agility
  • Proximity search
  • Scanning mode – extremely low latency for asynchronous applications such as remote control
  • Low priority search – does not impact existing channels
  • Channel ID management – improve device pairing efficiency
  • Individual output power control per channel

Features

  • Fully embedded, enhanced ANT protocol stack
  • 2.4GHz ISM band, 78 selectable RF channels
  • 1Mbps RF data rate
  • Up to 8 independent ANT channels
  • Broadcast, acknowledged or burst data transfer
  • Simple synchronous or asynchronous serial interface
  • Up to 3 public, managed and/or private network keys
  • 8 byte data payload per message
  • Minimum message rate per ANT channel 0.5Hz
  • ANT channel combined message rate up to 190Hz
  • Burst transfer rate up to 20Kbps (true data throughput)
  • Simple to complex network topologies: Peer-to-peer, star, tree and practical mesh
  • Built-in device search and pairing
  • Built-in timing and power management
  • Built-in interference handling
  • on-chip 32.768 kHz crystal oscillator
  • Fully interoperable with nRF24APx and AT3 chipset / module based products
  • QFN 6x6 package
  • 40°C to +85°C operating temperature

The TI Evaluation Kit contains everything needed to quickly explore and develop with the CC257x, including the Integrated ANT-FS feature. The Evaluation kit contaons the following components:

  • 4X CC2571 Modules
  • 2X EEPROM Boards
  • 2X Battery Boards
  • 2X USB Sticks
  • 2X CR2032 coin cell batteries

ti.com

You may have to register before you can post comments and get full access to forum.
EMS supplier