Circuits & Schematics Measurement: oscilloscope - 2

Subsection: "Measurement"
  Including:
  Oscilloscopes
Search results: 43 Output: 11-20
  1. .. of the microcontroller for measurement of the heart beat rate in BPM. The output voltage waveform can also be viewed on an oscilloscope. I connected Digilent’s Analog Discovery tool to check the input PPG and the output ...
    24-12-2012
  1. .. and the transistors can be changed to most compatible NPN transistors. You can also view the crystal waveform on an oscilloscope by connecting a probe to either the base or emitter of transistor Q1. The Eagle files for this ...
    21-05-2009
  1. .. the dual opamp (or a pair of single opamps can be used - note that their pinouts are completely different). If you have an oscilloscope or can get access to one, check that the noise output is not clipping (you won't be able to ...
    26-03-2010
  2. .. Miniature scope is equipped with 0.96” OLED display where signals are viewed. The Xprotolab is the first mixed signal oscilloscope with an arbitrary waveform generator in a DIP module. It measures only 1 x 1.6 inches, and can be ...
    06-01-2011
  3. .. 1. Schematic The Xprotolab is a fully featured Mixed Signal Oscilloscope (MSO) with Spectrum Analyzer and Arbitrary Waveform Generator (AWG). The Xprotolab can also be ...
    13-01-2011
  4. .. an analogue wave with a peak-to-peak intensity of 1V centred around 0V (i.e. it is an AC signal) as shown by the following oscilloscope trace (from pin W2 of the demo board): The picture shows a full-volume 5000Hz sine wave generated ...
    18-01-2011
  5. .. I don't have an oscilloscope yet so I needed a cheap way to analyze some signals, I decided to build a simple logic analyzer ...
    09-05-2010
  6. .. excess noise from an oscilloscope probe yields better measurements You must minimize noise when measuring ripple in power rails ...
    12-03-2012
  7. .. 100 ppm which is not suitable for any accurate measurements. If we have another device to measure the exact frequency (eg oscilloscope with hardware measurement), we can calibrate our circuit by adding a little trimming (cap pot) ...
    17-05-2013
  8. .. Phase. Jitter. Jitter - Jitter is the short-term frequency instability and is normally seen in the time domain on an oscilloscope. Phase Noise - Phase Noise is a ratio of signal power to noise power normalized to a 1 Hz ...
    30-11-2013

Sort by: relevance / date

Search "oscilloscope" on other search engines: Only-DataSheet.com Google
EMS supplier