Circuits & Schematics Microcontrollers Usage: programmer - 5

Subsection: "Microcontrollers Usage"
  Including:
  AVR   Clock   PIC   Programmer
Search results: 64 Output: 41-50
  1. .. Click to enlarge MCU I build it around Microchip PIC16F917 , with internal Oscillator at 4MHz. I also build a serial port programmer, so I can programming it on-line, using the DL4YHF WinPic. Download source code in .asm Clock I use a ...
    04-11-2010
  1. .. for making the led mood lamp. 3 x NPN transistors capable of driving 500 mA, for example the BC337 one PIC 16F628(A) and a programmer a small perforated circuit board 7 x 10K resistors (1/4W) 1/2 watt resistors (2x 22 Ohm, 4x 10 Ohm) ...
    08-11-2010
  1. .. = 8uS / 16 pixels == 500nS / pixel One gain division consists of 16 pixels Besides the power supply, you need an external programmer, such as the AVR ISP 2 , or a debugger, such as the AVR JTAGICE mkII or the AVR ONE! . Sofware Tools: ...
    13-01-2011
  2. .. it will immediately start running. U9 can be programmed with one of the two available connectors J4 or J4A depending on the programmer type. It is possible to need to disconnect the Vcc from U9 during programming. For that purpose JP1 ...
    01-02-2011
  3. .. hex file ( sdsg_mo.hex/sdsg_st.hex/sdsg_hr.hex ). The fuse settings are combined with the hex files, however, some flash programmer does not support this sort of hex files. In this case, remove last three lines from the hex file and ...
    14-03-2011
  4. .. hex file ( sdsg_mo.hex/sdsg_st.hex/sdsg_hr.hex ). The fuse settings are combined with the hex files, however, some flash programmer does not support this sort of hex files. In this case, remove last three lines from the hex file and ...
    17-03-2011
  5. .. bits. Software As usual, I used my favorite mikroC compiler from mikroElektronika for programming the PIC. No external programmer is required with StartUSB board as the on-board PIC has pre-programmed with mikroElektronika ’s ...
    14-05-2011
  6. .. pin as io as the io pin count is low. But doing so will disable further programming via SPI. I do not need a full blown HV programmer, just a way to revert these devices to factory default fuse settings so that i can use SPI to flash ...
    22-05-2011
  7. .. the port with a terminal program and the power will on. Check that the Vcc voltage is within 5 0.1 volts. Attach the flash programmer to the ISP connector and write firmware and fuse value into the microcontroller. The programming can ...
    06-06-2011
  8. .. make sure you are properly programmed tiny, because after setting that fuse you lose access to the tiny with typical ISP programmer. ATTACHMENT UPDATED program tiny13lcd_9_64-sample make 64 samples for each one measurement and ...
    10-06-2011

Sort by: relevance / date

Search "programmer" on other search engines: Only-DataSheet.com Google
EMS supplier