Circuits & Schematics: www.aaroncake.net - 10

Search for: "www.aaroncake.net"
Search results: 118 Output: 91-100   Including: net (80); www (47); aaroncake (2).
  1. .. less than 1% transfer-function nonlinearity. With suitable adjustment of the SPAN potentiometer, a 50-mV input produces a net Q 2 , Q 3 , Q 4 composite current of 500 µA and 5 V output voltage, ideal for direct input to a typical A/D ...
    03-11-2016
  1. .. linearization with constant loop gain. E is the product of A and C and is the achieved loop-gain linearization. The net result is a linear relationship between the control circuit and heater outputs and a consequent optimization of the ...
    26-04-2017
  1. .. by Gordon Henderson. First off, install the wiringpi library: mkdir development cd development git clone git://git.drogon.net/wiringPi cd wiringPi ./build Next, save the following code into a file called voltmeter.c . The code can be ...
    13-09-2017
  2. .. a cascade of the autozeroed AD8231 instrumentation amp, IC 1 , with a preset voltage gain of eight, IC 2 , and IC 3 . The net result is that the input-voltage offset of IC 2 causes an RTI (referred-to-input) voltage offset, which decreases ...
    08-02-2018
  3. Circuits Supply Texas Instruments LM2682 LMH6672 LMV431
    .. Q 1 , the 2N2222 transistor. The configuration of the transistor causes a V BE drop of approximately 0.7 V, resulting in a net voltage of 5 V for the next stage. The purpose of the transistor is to provide additional current to the LM2682 ...
    17-04-2018
  4. .. behind the circuit in Figure 1 is to check the influence of a dc bias voltage on the frequency of a simple oscillator. The net result is a low-frequency VCO with a relatively large voltage-gain figure, which depends largely on the type of ...
    29-01-2019
  5. .. signal paths present 5.5-kΩ impedances to each of the A and B amplifier sections' inputs. By inspection, the net 5.5-kΩ impedance from Section B's output to C 1 comprises the Thevenin-equivalent impedance of resistors ...
    03-09-2019
  6. .. log-ratio calculation by D3, D4, and A2 taken from reference optos O3 and O4, controlled by feedback amplifier A3. The net result is that, in nulling A2’s output, A3 implicitly calculates a drive signal for O3/O4 that accurately and ...
    20-10-2019
  7. .. the complexity of bidirectional drive. It works by exploiting a little-known quirk of all TECs: the inherent reversal of net heat flow at unconventionally high levels of drive current. Figure 2. This circuit puts unipolar drive in a ...
    03-12-2019
  8. .. at either A or B forms the emitter current and is of more concern with regard to the limited 1-mA sink of the CMOS. With a net 1-mA current and approximately 250 uA remaining for the output load, you must choose a 6.8-kΩ resistor (0.75 ...
    17-03-2020

Sort by: relevance / date

Search "www.aaroncake.net" on other search engines: Only-DataSheet.com Google
EMS supplier