Radiolocman.com - All about electronics

Circuits & Schematics Analogue Design - 9

Subsection: "Analogue Design"
Search results: 327 Output: 81-90
  1. Accurate op amps have high open-loop gain, low offset voltage and current, low voltage and current noise, and low distortion. However, they often lack the ability to provide high output currents while maintaining all the other high-accuracy ...
    18-04-2021
  2. Light sensors find use in a host of important applications, spanning from consumer electronics, such as ambient-light measurements and exposure control for cameras, to scientific instruments, such as optical-absorption spectroscopy, IR (infrared) ...
    14-04-2021
  1. The gate-turn-on threshold voltage for GaAs MESFETs (gallium-arsenide metal-semiconductor field-effect transistors) varies considerably from part to part, even within a given lot. That behavior makes biasing difficult, especially if you want to ...
    13-04-2021
  2. Instrumentation amplifiers serve in a variety of applications that need to extract a weak differential signal from large common-mode noise or interference. However, designers often overlook the potential problem of RF rectification inside the ...
    04-04-2021
  3. The LM324 is a cost-effective choice for an op amp, especially when you need to apply ground-level inputs. Although its output purportedly includes ground, its poor current-sinking capability limits the applications. At output voltages lower than ...
    17-02-2021
  4. The growth of battery-operated applications has put steady pressure on designers to steeply reduce their products’ operational power consumption and bring standby power as close to zero as possible by carefully managing the devices’ ...
    10-02-2021
  5. Many single-supply-powered applications require amplifier-output swings within 1 mV or even submillivolts of ground. Amplifier-output-saturation limitations normally preclude such operation. Figure 1. This configuration uses bootstrapping to allow ...
    04-02-2021
  6. Battery-operated equipment often requires a low-voltage monitor to warn the user when the battery voltage is too low or to perform other functions, such as power-source switching or device shutdown. Many specialized ICs are available to satisfy ...
    29-01-2021
  7. The Sallen-Key realization of a 5.25-MHz, three-pole Butterworth filter has a gain of 2 V/V and can drive 75 Ω back-terminated coax with an overall gain of 1 (Figure 1). Used to reconstruct component-video (Y, Pb, Pr) and RGB signals, this ...
    15-01-2021
  8. Figure 1a shows the classic implementation of an integrator. The circuit has two properties that may be undesirable in same applications: It necessarily inverts, and it requires a split-supply or midsupply reference. Figure 1b shows an ...
    04-01-2021
EMS supplier