Electronics ru
Advanced Search +

Datasheet Texas Instruments CC2530F32RHAT

Datasheet Texas Instruments CC2530F32RHAT

ManufacturerTexas Instruments
Part NumberCC2530F32RHAT

Second Generation System-on-Chip Solution for 2.4 GHz IEEE 802.15.4 / RF4CE / ZigBee 40-VQFN -40 to 125


  • Download » Datasheet, PDF, 974 Kb, Revision: B, 10-05-2010, File uploaded 03-20-2018
    CC2530 datasheet
    Docket ↓
    CC2530F32, CC2530F64
    CC2530F128, CC2530F256
    SWRS081B – APRIL 2009 – REVISED FEBRUARY 2011 A True System-on-Chip Solution for 2.4-GHz IEEE 802.15.4 and ZigBee Applications
    Check for Samples: CC2530F32, CC2530F64, CC2530F128, CC2530F256 FEATURES 1 RF/Layout
    – 2.4-GHz IEEE 802.15.4 Compliant RF
    – Excellent Receiver Sensitivity and
    Robustness to Interference
    – Programmable Output Power Up to 4.5 dBm
    – Very Few External Components
    – Only a Single Crystal Needed for
    Asynchronous Networks
    – 6-mm × 6-mm QFN40 Package
    – Suitable for Systems Targeting Compliance
    With Worldwide Radio-Frequency
    Regulations: ETSI EN 300 328 and EN 300
    440 (Europe), FCC CFR47 Part 15 (US) and
    ARIB STD-T-66 (Japan) Low Power
    – Active-Mode RX (CPU Idle): 24 mA
    – Active Mode TX at 1 dBm (CPU Idle): 29 mA
    – Power Mode 1 (4 μs Wake-Up): 0.2 mA
    – Power Mode 2 (Sleep Timer Running): 1 μA
    – Power Mode 3 (External Interrupts): 0.4 μA ...


Family: CC2530, CC2530-RF4CE


Lifecycle StatusActive (Recommended for new designs)
Manufacture's Sample AvailabilityNo


Package TypeRHARHA
Package QTY250250
Device MarkingF32CC2530
Width (mm)66
Length (mm)66
Thickness (mm).9.9
Pitch (mm).5.5
Max Height (mm)11
Mechanical DataDownload »Download »


ADC12-bit, 8 channel
Data Rate(Max)250 kbps
Device TypeWireless MCU
FlashUp to 256 KB
Frequency24 MHz
Frequency(Max)2507 MHz
Frequency(Min)2394 MHz
Key Applications2.4-GHz IEEE 802.15.4 Systems, RF4CE Remote Control Systems (64-KB Flash and Higher), ZigBee Systems (256-KB Flash), Home/Building Automation, Lighting Systems, Industrial Control and Monitoring, Low-Power Wireless Sensor Networks, Consumer Electronics, Health Care
Operating Temperature Range-40 to 125 C
Output Power4.5 dBm
Over-the-air UpgradeNo
Package GroupVQFN
RX Current (Lowest)20.5 mA
RX Sensitivity-97 dBm
Security128-bit AES
Sleep Current0.4 uA
Throughput(Max)0.25 Mbps
Timers - 16-bit1

Eco Plan


Design Kits & Evaluation Modules

  • Daughter Cards: CC2530EMK
    CC2530 Evaluation Module Kit
    Lifecycle Status: Active (Recommended for new designs)
  • Development Kits: CC2530ZDK-ZLL
    CC2530 ZigBee Light Link Development Kit
    Lifecycle Status: Active (Recommended for new designs)
  • Daughter Cards: CC2531EMK
    CC2531 USB Evaluation Module Kit
    Lifecycle Status: Active (Recommended for new designs)
  • JTAG Emulators/ Analyzers: CC-DEBUGGER
    Debugger and Programmer for RF System-on-Chips
    Lifecycle Status: Active (Recommended for new designs)

Application Notes

  • Download » Application Notes, PDF, 1.2 Mb, 08-10-2011
    AN104 -- TDK Corporation balun optimized for CC253x
    CC2530, CC2540, CC8520 AN104 -- TDK Corporation balun optimized for CC253x
  • Download » Application Notes, PDF, 877 Kb, 09-28-2012
    AN079 -- Measuring Power Consumption of CC2530 with Z-Stack
  • Download » Application Notes, PDF, 3.8 Mb, 01-10-2014
    Developing a ZigBee System Using CC2530-ZNP Approach
    CC2530 Developing a ZigBee System Using CC2530-ZNP Approach
  • Download » Application Notes, PDF, 227 Kb, 12-12-2011
    AN114 -- Z-Stack Duty Cycle Analysis
    Z-Stack Duty Cycle Analysis
  • Download » Application Notes, PDF, 217 Kb, 05-20-2009
    AN074 -- RemoTI Coexistence Testing
  • Download » Application Notes, PDF, 2.1 Mb, 10-17-2013
    CC2530 With Skyworks’ SE2431L Range Extender Front End
    This application report describes the expected performance of the CC2530 and the SE2431L module. The combined CC2530 and SE2431L solution is suitable for systems targeting compliance with FCC CFR47 Part 15.The RF front end of CC2530 has the same settings as the ones being used in CC2531. Therefore, the presented results are also valid for CC2531.
  • Download » Application Notes, PDF, 541 Kb, Revision: A, 07-29-2015
    Using CC2592 Front End with CC2530 (Rev. A)
    This application report describes the pairing of the cost-effective SimpleLink™ ZigBee CC2530 wireless MCU with the SimpleLink CC2592 range extender to improve the receiver sensitivity and increase the total link budget, enabling up to four times the range of each node in the ZigBee network. The combination of these devices creates a system solution that is ideal for applications such as hom
  • Download » Application Notes, PDF, 58 Kb, Revision: A, 07-12-2009
    CC2530 FAQ (Rev. A)
  • Download » Application Notes, PDF, 800 Kb, Revision: C, 03-12-2013
    AN084 - RemoTI SimpleConsole Application (Rev. C)
  • Download » Application Notes, PDF, 117 Kb, 04-29-2009
    AN071 -- CC2430 to CC2530 Migration Guide
  • Download » Application Notes, PDF, 836 Kb, 11-18-2011
    AN111 - Using RF6505 Front End Module with CC2530 under FCC 15.247
  • Download » Application Notes, PDF, 742 Kb, 10-01-2014
    Final Test Considerations for Wireless Technology Products
    Low Power Wireless Radio as a technology is of great application to many of the products where wireless connectivity is needed. But the world of RF is completely different from the conventional development environment perspective, as the frequencies involved make the testing of such systems more complex. Texas Instruments has a huge portfolio of Low Power Wireless Simple Link solutions catering th
  • Download » Application Notes, PDF, 451 Kb, 07-28-2011
    DN037 -- Measurement Results for Combined CC2530 and CC2590 Solution
  • Download » Application Notes, PDF, 216 Kb, 11-09-2009
    AN078 -- TIMAC and Z-Stack Modifications for using CC2591 RF Front End with CC2
    This application note describes how to modify the TI-MAC (v1.3.0) / Z-Stack (v2.2.0) software releases for the CC2530 SoC to support CC2591 PA/LNA controls.
  • Download » Application Notes, PDF, 327 Kb, Revision: A, 12-16-2009
    AN086 -- Using CC2591 Front End with CC2530 and CC2531 (Rev. A)
    This application note is targeted designers of RF systems with CC2530/CC2531 and the CC2591 RF Power Amplifier (PA). It describes how to implement the CC2530 and the CC2591 in the same design. It further describes the expected performance from this combination as well as important factors to consider with respect to the layout and regulatory requirements. The combined CC2530 and CC2591 soluti
  • Download » Application Notes, PDF, 828 Kb, Revision: B, 12-16-2014
    RemoTI™ Capacitive Touch Sensing (Rev. B)
    As consumers become accustomed to elegant touch interfaces on a variety of devices, these capabilities are becoming more expected on a greater number of devices. The CC253x devices used in RF4CE applications provide hardware support for Capacitive Touch Sensing (Capacitive Sensing),
  • Download » Application Notes, PDF, 584 Kb, Revision: A, 08-18-2009
    AN060 - Security on TI IEEE 802.15.4 Compliant RF Devices (Rev. A)
    AN060 - Security on TI IEEE 802.15.4 Compliant RF DevicesThis application note introduces IEEE 802.15.4 security and gives practical examples using Texas Instruments’ family of IEEE 802.15.4 compliant RF chipsets; the CC2420, CC2430, CC2520 andCC2530. The main focus will be on the CC2520, TI’s second-generation IEEE 802.15.4 compliant RF transceiver. This document will also explain how to impl
  • Download » Application Notes, PDF, 110 Kb, Revision: C, 11-26-2013
    AN100 - Crystal Selection Guide (Rev. C)
    RF systems are highly dependent on accurate clocks for correct operation. A deviation in clock frequency is directly reflected as a deviation in radio frequency. This can degrade RF performance, violate legal requirements or in worst case lead to a non-functioning system. The scope of this application report is to give the design engineer a quick guide on how to design, tune and verify the
  • Download » Application Notes, PDF, 733 Kb, 01-24-2013
    DN041 -- Using CC253X or CC254X with Dipole PCB Antenna
  • Download » Application Notes, PDF, 426 Kb, 09-05-2012
    AN118 -- Flash programming of CC253x/4x devices
    Application note AN118 demonstrates how to use the CC debug interface to perform various flash related tasks on CC253x / CC254x System-on-Chips. It is distributed along with a example code using a CC2530 as a programmer – but is easily ported to other devices. The application note explains in detail the example code, which covers how to enter debug mode and how to read/write/erase the flash memory
  • Download » Application Notes, PDF, 805 Kb, Revision: A, 10-26-2011
    AN107 - Murata Balun for CC253x and CC254x, LFB182G45BG2D280 (Rev. A)
  • Download » Application Notes, PDF, 211 Kb, 08-03-2009
    DN116 -- Clearing Module Interrupt Flags in LPW SoC Devices
  • Download » Application Notes, PDF, 133 Kb, Revision: A, 08-11-2009
    DN113 CC111xFx CC243xFx CC251xFx CC253xFx SPI Interface (Rev. A)
    The purpose of this design note is to describe how to operate the two USARTs in synchronous SPI mode, both as a master and as a slave.
  • Download » Application Notes, PDF, 605 Kb, 09-22-2009
    DN117 -- SimpliciTI-compatible UART Driver
  • Download » Application Notes, PDF, 210 Kb, Revision: B, 08-11-2009
    DN112 -- Using UART in CC111xFx CC243x CC251xFx and CC253xFx (Rev. B)
    This design note describes the key elements and simple usage of the CC111xFx/CC243xFx/CC251xFx/CC253xFx USART peripheral in UART mode. The main objective is to explain the CC111xFx/CC243xFx/CC251xFx/CC253xFx software required to operate the UART, with and without DMA support.
  • Download » Application Notes, PDF, 456 Kb, Revision: B, 11-06-2012
    AN081 -- Johanson Technology Balun Optimized for CC253X, CC254X, CC257X, CC853X (Rev. B)
  • Download » Application Notes, PDF, 596 Kb, 08-08-2011
    AN103 -- Basic RF Testing of CCxxxx Devices
    This document presents users of Texas Instruments' low-power RF products with an overview of the different characterization tests (conducted, not radiated) that are performed during the device verification process. The document covers the basic setup of the test system and gives procedural information about each test.
  • Download » Application Notes, PDF, 2.4 Mb, 02-08-2017
    ETSI EN 300 328 Blocking Test for Bluetooth Low Energy
    This application report describes the setup and procedure used to measure the new ETSI EN receiver (RX) blocking test added to version v2.1.1 of the ETSI EN 300 328 harmonized standard.
  • Download » Application Notes, PDF, 456 Kb, Revision: A, 08-02-2012
    AN098 - Layout Review Techniques for Low Power RF Designs (Rev. A)
  • Download » Application Notes, PDF, 1.9 Mb, 10-14-2010
    DN034 -- YAGI 2.4 GHz PCB Antenna
  • Download » Application Notes, PDF, 126 Kb, Revision: T, 10-12-2011
    DN000 - Design Note Overview (Rev. T)
  • Download » Application Notes, PDF, 2.3 Mb, 08-26-2010
    DN031 -- CC-Antenna-DK Documentation and Antenna Measurements Summary
    DN031 -- Design Notes
  • Download » Application Notes, PDF, 1.8 Mb, Revision: B, 10-06-2010
    AN058 -- Antenna Selection Guide (Rev. B)
  • Download » Application Notes, PDF, 138 Kb, Revision: A, 02-12-2013
    DN035 -- Antenna Quick Guide (Rev. A)

Moldel Line

Series: CC2530 (9)

Manufacturer's Classification

  • Semiconductors > Wireless Connectivity > ZigBee
Slices ↓
Radiolocman facebook Radiolocman twitter Radiolocman google plus