Datasheet Texas Instruments CC2533F96RHAR

ManufacturerTexas Instruments
SeriesCC2533
Part NumberCC2533F96RHAR
Datasheet Texas Instruments CC2533F96RHAR

A True System-on-Chip Solution for 2.4-GHz IEEE 802.15.4 and ZigBee Applications 40-VQFN -40 to 125

Datasheets

An Optimized System-on-Chip Solution for 2.4-GHz IEEE 802.15.4 Remote Control Ap datasheet
PDF, 1.1 Mb, File published: Jun 25, 2010
Extract from the document

Prices

Status

Lifecycle StatusActive (Recommended for new designs)
Manufacture's Sample AvailabilityYes

Packaging

Pin4040
Package TypeRHARHA
Industry STD TermVQFNVQFN
JEDEC CodeS-PQFP-NS-PQFP-N
Package QTY25002500
CarrierLARGE T&RLARGE T&R
Device MarkingF96CC2533
Width (mm)66
Length (mm)66
Thickness (mm).9.9
Pitch (mm).5.5
Max Height (mm)11
Mechanical DataDownloadDownload

Parametrics

AES 128 Bit Hardware EncryptionYes
Data Rate(Max)250 kbps
Device TypeWireless MCU
FlashUp to 96 KB
Frequency24 MHz
Package Size: mm2:W x L40VQFN: 36 mm2: 6 x 6(VQFN) PKG
RAM size4,4,6 KB
RX Current (Lowest)20.0 mA
Sensitivity (Best)-97 dBm
Standby Power0.4 LPM3-uA
TX Power7 dBm
TechnologyRF4CE,SimpleLink CC2x
Throughput(Max)0.25 Mbps
USB 2.0No
Wakeup Time (PD-->RX/TX)600 us

Eco Plan

RoHSCompliant

Design Kits & Evaluation Modules

  • JTAG Emulators/ Analyzers: CC-DEBUGGER
    Debugger and Programmer for RF System-on-Chips
    Lifecycle Status: Active (Recommended for new designs)
  • Daughter Cards: CC2533EMK
    CC2533 Evaluation Module Kit
    Lifecycle Status: Active (Recommended for new designs)
  • Development Kits: CC2533DK-RF4CE-BA
    CC2533 RF4CE Development Kit
    Lifecycle Status: Obsolete (Manufacturer has discontinued the production of the device)
  • Daughter Cards: CC2531EMK
    CC2531 USB Evaluation Module Kit
    Lifecycle Status: Active (Recommended for new designs)

Application Notes

  • Guide for Manufacture Testing of RF4CE Products
    PDF, 11.8 Mb, File published: Jan 9, 2015
    This application report describes a sample implementation of a manufacturing line test program for RF4CE products. It is based on RemoTI-Linux, which is the Linux host driver for CC253x RemoTI Network Processor (RNP). It includes the ability to setup a fake pairing between the remote control and target side, how to enter test mode, how to change RF parameters, and so forth. It helps customers to u
  • RemoTIв„ў Capacitive Touch Sensing (Rev. B)
    PDF, 828 Kb, Revision: B, File published: Dec 16, 2014
    As consumers become accustomed to elegant touch interfaces on a variety of devices, these capabilities are becoming more expected on a greater number of devices. The CC253x devices used in RF4CE applications provide hardware support for Capacitive Touch Sensing (Capacitive Sensing),
  • AN100 - Crystal Selection Guide (Rev. C)
    PDF, 110 Kb, Revision: C, File published: Nov 26, 2013
    RF systems are highly dependent on accurate clocks for correct operation. A deviation in clock frequency is directly reflected as a deviation in radio frequency. This can degrade RF performance, violate legal requirements or in worst case lead to a non-functioning system. The scope of this application report is to give the design engineer a quick guide on how to design, tune and verify the
  • Voice Over Remote Control
    PDF, 112 Kb, File published: May 19, 2016
    This application report describes the voice over RF protocol used for Texas Instruments Bluetooth В® low energy (BLE) and RF4CE remote control solutions.
  • DN041 -- Using CC253X or CC254X with Dipole PCB Antenna
    PDF, 733 Kb, File published: Jan 24, 2013
  • AN118 -- Flash programming of CC253x/4x devices
    PDF, 426 Kb, File published: Sep 5, 2012
    Application note AN118 demonstrates how to use the CC debug interface to perform various flash related tasks on CC253x / CC254x System-on-Chips. It is distributed along with a example code using a CC2530 as a programmer – but is easily ported to other devices. The application note explains in detail the example code, which covers how to enter debug mode and how to read/write/erase the flash memory
  • AN107 - Murata Balun for CC253x and CC254x, LFB182G45BG2D280 (Rev. A)
    PDF, 805 Kb, Revision: A, File published: Oct 26, 2011
  • AN081 -- Johanson Technology Balun Optimized for CC253X, CC254X, CC257X, CC853X (Rev. B)
    PDF, 456 Kb, Revision: B, File published: Nov 6, 2012
  • ETSI EN 300 328 Blocking Test for Bluetooth Low Energy
    PDF, 2.4 Mb, File published: Feb 8, 2017
    This application report describes the setup and procedure used to measure the new ETSI EN receiver (RX) blocking test added to version v2.1.1 of the ETSI EN 300 328 harmonized standard.
  • AN098 - Layout Review Techniques for Low Power RF Designs (Rev. A)
    PDF, 456 Kb, Revision: A, File published: Aug 2, 2012
  • DN034 -- YAGI 2.4 GHz PCB Antenna
    PDF, 1.9 Mb, File published: Oct 14, 2010
  • DN000 - Design Note Overview (Rev. T)
    PDF, 126 Kb, Revision: T, File published: Oct 12, 2011
  • DN031 -- CC-Antenna-DK Documentation and Antenna Measurements Summary
    PDF, 2.3 Mb, File published: Aug 26, 2010
    DN031 -- Design Notes
  • AN058 -- Antenna Selection Guide (Rev. B)
    PDF, 1.8 Mb, Revision: B, File published: Oct 6, 2010
  • DN035 -- Antenna Quick Guide (Rev. A)
    PDF, 138 Kb, Revision: A, File published: Feb 12, 2013

Model Line

Manufacturer's Classification

  • Semiconductors > Wireless Connectivity > RF4CE
EMS supplier