Datasheet Texas Instruments LM324Y

ManufacturerTexas Instruments
SeriesLM324
Part NumberLM324Y
Datasheet Texas Instruments LM324Y

Quadruple Operational Amplifier 0-DIESALE

Datasheets

Datasheet LM124, LM124A, LM124M, LM224, LM224A, LM224K, LM224KA, LM2902, LM2902K, LM2902KAV, LM2902KV, LM2902V, LM324, LM324A, LM324K, LM324KA
PDF, 1.8 Mb, Revision: W, File published: Mar 30, 2014, Pages: 42
Quadruple Operational Amplifiers
Extract from the document

Prices

Status

Lifecycle StatusObsolete (Manufacturer has discontinued the production of the device)
Manufacture's Sample AvailabilityNo

Packaging

Package TypeY

Parametrics

Additional FeaturesN/A
Approx. Price (US$)0.07 | 1ku
ArchitectureBipolar
CMRR(Min)(dB)65
CMRR(Typ)(dB)80
GBW(Typ)(MHz)1.2
Input Bias Current(Max)(pA)250000
Iq per channel(Max)(mA)0.3
Iq per channel(Typ)(mA)0.175
Number of Channels(#)4
Offset Drift(Typ)(uV/C)7
Operating Temperature Range(C)-40 to 85
0 to 70
Output Current(Typ)(mA)40
Package GroupPDIP
SO
SOIC
TSSOP
WAFERSALE
Package Size: mm2:W x L (PKG)See datasheet (PDIP)
Rail-to-RailIn to V-
RatingCatalog
Slew Rate(Typ)(V/us)0.5
Total Supply Voltage(Max)(+5V=5, +/-5V=10)32
Total Supply Voltage(Min)(+5V=5, +/-5V=10)3
Vn at 1kHz(Typ)(nV/rtHz)35
Vos (Offset Voltage @ 25C)(Max)(mV)7

Eco Plan

RoHSNot Compliant
Pb FreeNo

Application Notes

  • AN-260 A 20-Bit (1 ppm) Linear Slope-Integrating A/D Converter (Rev. B)
    PDF, 502 Kb, Revision: B, File published: May 5, 2013
    This application report discusses how combining an “inferior”, 20 year old A/D conversion technique with amicroprocessor, a developmental A/D converter achieves 1 part-per-million (20-bit) linearity.
  • True RMS Detector
    PDF, 88 Kb, File published: Oct 1, 2002
  • AN-29 IC Op Amp Beats FETs on Input Current (Rev. B)
    PDF, 965 Kb, Revision: B, File published: May 1, 2013
    This application note describes a monolithic operational amplifier which has input error currents in theorder of 100 pA over a в€’55В°C to 125В°C temperature range. Instead of FETs, the circuit used bipolartransistors with current gains of 5000 so that offset voltage and drift are not degraded. A powerconsumption of 1 mW at low voltage is also featured.A number of novel circuits that make use
  • AN-24 A Simplified Test Set for Op Amp Characterization
    PDF, 1.2 Mb, File published: May 10, 2004
    Application Note 24 A Simplified Test Set for Op Amp Characterization
  • AN-20 An Applications Guide for Op Amps (Rev. C)
    PDF, 727 Kb, Revision: C, File published: May 1, 2013
    This application note is a guide for Op Amps. The circuits discussed herein are illustrative of the versatilityof the integrated operational amplifier and provide a guide to a number of useful applications. Thecautions noted in each section will show the more common pitfalls encountered in amplifier usage.
  • AN-4 Monolithic Op Amp—The Universal Linear Component (Rev. B)
    PDF, 579 Kb, Revision: B, File published: May 1, 2013
    Operational amplifiers are undoubtedly the easiest and best way of performing a wide range of linearfunctions from simple amplification to complex analog computation. The cost of monolithic amplifiers isnow less than $2.00, in large quantities, which makes it attractive to design them into circuits where theywould not otherwise be considered. Yet low cost is not the only attraction of monoli
  • AN-32 FET Circuit Applications
    PDF, 254 Kb, File published: May 10, 2004
  • AN-31 Op Amp Circuit Collection (Rev. B)
    PDF, 2.3 Mb, Revision: B, File published: May 1, 2013
    This application report provides basic circuits of the Texas Instruments op amp collection.
  • AN-30 Log Converters (Rev. B)
    PDF, 370 Kb, Revision: B, File published: May 1, 2013
    One of the most predictable non-linear elements commonly available is the bipolar transistor. Therelationship between collector current and emitter base voltage is precisely logarithmic from currentsbelow one picoamp to currents above one milliamp. Using a matched pair of transistors and integratedcircuit operational amplifiers it is relatively easy to construct a linear to logarithmic conv
  • AN-241 Working with High Impedance Op Amps
    PDF, 169 Kb, File published: May 3, 2004
    Application Note 241 Working with High Impedance Op Amps
  • AB-24 Bench Testing LM3900 and LM359 Input Parameters
    PDF, 142 Kb, File published: May 10, 2004
    Application Brief 24 Bench Testing LM3900 and LM359 Input Parameters
  • AN-278 Designing with a New Super Fast Dual Norton Amplifier (Rev. B)
    PDF, 867 Kb, Revision: B, File published: Apr 23, 2013
    This application note provides new design ideas and discusses the positive impact of designing with theDual Norton amplifier.
  • AN-446 A 150W IC Op Amp Simplifies Design of Power Circuits
    PDF, 782 Kb, File published: May 10, 2004
    Application Note 446 A 150W IC Op Amp Simplifies Design of Power Circuits
  • Building an Op Amp With Bipolar Transistors, A Historical Application Note (Rev. A)
    PDF, 1.2 Mb, Revision: A, File published: Sep 19, 2016
    It is well known that the voltage noise of an operational amplifier can be decreased by increasing the emitter currentof the input stage. The signal-to-noise ratio will be improved by the increase of bias, until the base current noise begins to dominate.
  • Precise Tri-Wave Generation
    PDF, 80 Kb, File published: Oct 2, 2002
  • AN-A The Monolithic Operational Amplifier: A Tutorial Study
    PDF, 379 Kb, File published: May 11, 2004
  • AN-46 The Phase Locked Loop IC as a Communication System Building Block
    PDF, 314 Kb, File published: May 14, 2004
  • General Purpose Power Supply
    PDF, 94 Kb, File published: Oct 3, 2002
  • Low Drift Amplifiers
    PDF, 71 Kb, File published: Oct 2, 2002
  • AN-79 IC Preamplifier Challenges Choppers on Drift (Rev. B)
    PDF, 940 Kb, Revision: B, File published: May 1, 2013
    Since the introduction of monolithic IC amplifiers there has been a continual improvement in DC accuracy.Bias currents have been decreased by 5 orders of magnitude over the past 5 years. Low offset voltagedrift is also necessary in a high accuracy circuits. This is evidenced by the popularity of low drift amplifiertypes as well as the requests for selected low-drift op amps. However until n
  • Predicting Op Amp Slew Rate Limited Response
    PDF, 139 Kb, File published: Oct 7, 2002
  • AN-262 Applying Dual and Quad FET Op Amps (Rev. B)
    PDF, 1.1 Mb, Revision: B, File published: May 6, 2013
    The availability of dual and quad packaged FET op amps offers the designer all the traditional capabilitiesof FET op amps including low bias current and speed and some additional advantages. The cost-peramplifieris lower because of reduced package costs. This means that more amplifiers are available toimplement a function at a given cost making design easier. At the same time the availab
  • Audio Applications of Linear Integrated Circuits
    PDF, 272 Kb, File published: May 2, 2004
  • Applying a New Precision Op Amp
    PDF, 421 Kb, File published: Oct 4, 2004
  • AN-263 Sine Wave Generation Techniques (Rev. C)
    PDF, 747 Kb, Revision: C, File published: Apr 22, 2013
    This application note describes the sine wave generation techniques to control frequency amplitude anddistortion levels.
  • Super Matched Bipolar Transistor Pair Sets New Standards for Drift and Noise (Rev. B)
    PDF, 966 Kb, Revision: B, File published: May 5, 2013
    This application report discusses how a super matched bipolar transistor pair sets new standards for driftand noise.
  • AN-256 Circuitry for Inexpensive Relative Humidity Measurement (Rev. B)
    PDF, 262 Kb, Revision: B, File published: May 6, 2013
    Of all common environmental parameters humidity is perhaps the least understood and most difficult tomeasure. The most common electronic humidity detection methods albeit highly accurate are not obviousand tend to be expensive and complex (See Box). Accurate humidity measurement is vital to a number ofdiverse areas including food processing paper and lumber production pollution monitor
  • AN-480 A 40 MHz Programmable Video Op Amp
    PDF, 218 Kb, File published: May 11, 2004
  • Get More Power Out of Dual or Quad Op-Amps
    PDF, 91 Kb, File published: Oct 2, 2002
  • Get Fast Stable Response From Improved Unity-Gain Followers
    PDF, 107 Kb, File published: Oct 2, 2002

Model Line

Manufacturer's Classification

  • Semiconductors > Amplifiers > Operational Amplifiers (Op Amps) > General-Purpose Op Amps
EMS supplier