Datasheet Texas Instruments LM101A-N

ManufacturerTexas Instruments
SeriesLM101A-N
Datasheet Texas Instruments LM101A-N

Operational Amplifier

Datasheets

LM101A/LM201A/LM301A Operational Amplifiers datasheet
PDF, 1.0 Mb, Revision: D, File published: Mar 19, 2013
Extract from the document

Prices

Status

LM101AHLM101AH/NOPBLM101AJ
Lifecycle StatusActive (Recommended for new designs)Active (Recommended for new designs)Active (Recommended for new designs)
Manufacture's Sample AvailabilityNoNoYes

Packaging

LM101AHLM101AH/NOPBLM101AJ
N123
Pin888
Package TypeLMCLMCNAB
Industry STD TermTO-CANTO-CANCDIP
JEDEC CodeO-MBCY-WO-MBCY-WR-CDIP-P
Package QTY50050040
Device MarkingLM101AHLM101AHLM101AJ
Width (mm)9.089.086.502
Length (mm)9.089.0810.16
Thickness (mm)4.44.44.064
Pitch (mm)2.542.542.54
Max Height (mm)5.725.725.08
Mechanical DataDownloadDownloadDownload
CarrierTUBE

Parametrics

Parameters / ModelsLM101AH
LM101AH
LM101AH/NOPB
LM101AH/NOPB
LM101AJ
LM101AJ
Additional FeaturesN/AN/AN/A
ArchitectureBipolarBipolarBipolar
CMRR(Min), dB808080
CMRR(Typ), dB969696
GBW(Typ), MHz111
IIB(Max), pA750007500075000
Iq per channel(Max), mA333
Iq per channel(Typ), mA1.81.81.8
Number of Channels111
Offset Drift(Typ), uV/C333
Operating Temperature Range, C-55 to 125-55 to 125-55 to 125
Output Current(Typ), mA252525
Package GroupTO-99TO-99CDIP
Package Size: mm2:W x L, PKG8TO-99: 80 mm2: 8.96 x 8.96(TO-99)8TO-99: 80 mm2: 8.96 x 8.96(TO-99)See datasheet (CDIP)
Rail-to-RailIn to V+In to V+In to V+
RatingCatalogCatalogCatalog
Slew Rate(Typ), V/us0.50.50.5
Total Supply Voltage(Max), +5V=5, +/-5V=10444444
Total Supply Voltage(Min), +5V=5, +/-5V=10101010
Vn at 1kHz(Typ), nV/rtHz151515
Vos (Offset Voltage @ 25C)(Max), mV222

Eco Plan

LM101AHLM101AH/NOPBLM101AJ
RoHSSee ti.comCompliantSee ti.com

Application Notes

  • AN-71 Micropower Circuits Using the LM4250 Programmable Op Amp (Rev. B)
    PDF, 536 Kb, Revision: B, File published: May 1, 2013
    This application report describes the circuit operation of the Texas Instruments LM4250, various methodsof biasing the device, frequency response considerations, and some circuit applications exercising theunique characteristics of the LM4250.
  • LM118 Op Amp Slews 70 V/sec
    PDF, 118 Kb, File published: Oct 1, 2002
    LM118 Op Amp Slews 70 V/ГѓВґsec
  • AN-30 Log Converters (Rev. B)
    PDF, 370 Kb, Revision: B, File published: May 1, 2013
    One of the most predictable non-linear elements commonly available is the bipolar transistor. Therelationship between collector current and emitter base voltage is precisely logarithmic from currentsbelow one picoamp to currents above one milliamp. Using a matched pair of transistors and integratedcircuit operational amplifiers it is relatively easy to construct a linear to logarithmic conv
  • AN-20 An Applications Guide for Op Amps (Rev. C)
    PDF, 727 Kb, Revision: C, File published: May 1, 2013
    This application note is a guide for Op Amps. The circuits discussed herein are illustrative of the versatilityof the integrated operational amplifier and provide a guide to a number of useful applications. Thecautions noted in each section will show the more common pitfalls encountered in amplifier usage.
  • AN-24 A Simplified Test Set for Op Amp Characterization
    PDF, 1.2 Mb, File published: May 10, 2004
    Application Note 24 A Simplified Test Set for Op Amp Characterization
  • AN-29 IC Op Amp Beats FETs on Input Current (Rev. B)
    PDF, 965 Kb, Revision: B, File published: May 1, 2013
    This application note describes a monolithic operational amplifier which has input error currents in theorder of 100 pA over a в€’55В°C to 125В°C temperature range. Instead of FETs, the circuit used bipolartransistors with current gains of 5000 so that offset voltage and drift are not degraded. A powerconsumption of 1 mW at low voltage is also featured.A number of novel circuits that make use
  • AN-32 FET Circuit Applications
    PDF, 254 Kb, File published: May 10, 2004
  • AN-31 Op Amp Circuit Collection (Rev. B)
    PDF, 2.3 Mb, Revision: B, File published: May 1, 2013
    This application report provides basic circuits of the Texas Instruments op amp collection.
  • AN-4 Monolithic Op Amp—The Universal Linear Component (Rev. B)
    PDF, 579 Kb, Revision: B, File published: May 1, 2013
    Operational amplifiers are undoubtedly the easiest and best way of performing a wide range of linearfunctions from simple amplification to complex analog computation. The cost of monolithic amplifiers isnow less than $2.00, in large quantities, which makes it attractive to design them into circuits where theywould not otherwise be considered. Yet low cost is not the only attraction of monoli
  • AN-241 Working with High Impedance Op Amps
    PDF, 169 Kb, File published: May 3, 2004
    Application Note 241 Working with High Impedance Op Amps
  • AN-A The Monolithic Operational Amplifier: A Tutorial Study
    PDF, 379 Kb, File published: May 11, 2004
  • General Purpose Power Supply
    PDF, 94 Kb, File published: Oct 3, 2002
  • AN-46 The Phase Locked Loop IC as a Communication System Building Block
    PDF, 314 Kb, File published: May 14, 2004
  • AN-79 IC Preamplifier Challenges Choppers on Drift (Rev. B)
    PDF, 940 Kb, Revision: B, File published: May 1, 2013
    Since the introduction of monolithic IC amplifiers there has been a continual improvement in DC accuracy.Bias currents have been decreased by 5 orders of magnitude over the past 5 years. Low offset voltagedrift is also necessary in a high accuracy circuits. This is evidenced by the popularity of low drift amplifiertypes as well as the requests for selected low-drift op amps. However until n
  • Predicting Op Amp Slew Rate Limited Response
    PDF, 139 Kb, File published: Oct 7, 2002
  • Get Fast Stable Response From Improved Unity-Gain Followers
    PDF, 107 Kb, File published: Oct 2, 2002
  • AN-103 LM340 Series Three Terminal Positive Regulators (Rev. A)
    PDF, 814 Kb, Revision: A, File published: May 6, 2013
    The LM340-XX are three terminal 1.0A positive voltage regulators with preset output voltages of 5.0V or15V. The LM340 regulators are complete 3-terminal regulators requiring no external components fornormal operation. However by adding a few parts one may improve the transient response provide for avariable output voltage or increase the output current. Included on the chip are all of t

Model Line

Series: LM101A-N (3)

Manufacturer's Classification

  • Semiconductors> Space & High Reliability> Amplifier> Operational Amplifiers
EMS supplier