Datasheet Microchip MCP2510-E/SO | Manufacturer | Microchip | | Series | MCP2510 | | Part Number | MCP2510-E/SO |
Please consider this device MCP2515 View Side By Side Comparison Datasheets- Download » Datasheet, PDF, 1.0 Mb, 01-24-2007
MCP2510 Datasheet
Docket ↓MCP2510
Stand-Alone CAN Controller with SPIâ„¢ Interface
Features Description Implements Full CAN V2.0A and V2.0B at 1 Mb/s:
-0 -8 byte message length
-Standard and extended data frames
-Programmable bit rate up to 1 Mb/s
-Support for remote frames
-Two receive buffers with prioritized message
storage
-Six full acceptance filters
-Two full acceptance filter masks
-Three transmit buffers with prioritization and
abort features
-Loop-back mode for self test operation Hardware Features:
-High Speed SPI Interface
(5 MHz at 4.5V I temp)
-Supports SPI modes 0,0 and 1,1
-Clock out pin with programmable prescaler
-Interrupt output pin with selectable enables
-‘Buffer full’ output pins configureable as interrupt pins for each receive buffer or as general
purpose digital outputs
-‘Request to Send’ input pins configureable as
control pins to request immediate message ...
PricesStatus| Lifecycle Status | Not Recommended for new designs |
|---|
PackagingParametrics| Filters | 6 |
|---|
| Interrupt Output | 1 |
|---|
| Masks | 2 |
|---|
| Operating Temperature Range | -40 to +125 °C |
|---|
| Operating Voltage | 2.7 - 5.5 V |
|---|
| Rx Buffers | 2 |
|---|
| Temp. Range | -40 - +125 °C |
|---|
| Tx Buffers | 3 |
|---|
| Version Supported | 2.0B Active |
|---|
Eco PlanMoldel LineSeries: MCP2510 (8) Manufacturer's Classification- Interface and Connectivity > CAN > CAN External Controllers
Other Names:MCP2510E/SO, MCP2510 E/SO |
|
