In-circuit Programmer and debugger Cypress CY8CKIT-002

CY8CKIT-002 PSoC MiniProg3 Program and Debug Kit

CY8CKIT-002 Buy PriceBuy CY8CKIT-002 on RadioLocman.Price
AliExpress
Worldwide
CY8CKIT-002 PSoC MiniProg3 CYPRES Development Board Kit109 $

Detailed Description

The PSoC MiniProg3 Program and Debug Kit is an all-in-one programmer for PSoC 1, PSoC 3 and PSoC 5 architectures, debug tool for PSoC 3 and PSoC 5 architectures, and a USB-I2C Bridge for debugging I2C serial connections and communicating to PSoC devices.

The Miniprog3 supports the following protocols:

Included with the kit is a 10-pin ribbon cable for connecting to standard 10-pin JTAG header interfaces utilized for our PSoC 3 and PSoC 5 architectures while the device itself supports the 5-pin ISSP programming header for PSoC 1 architectures.

The 5-pin connector also supports the USB-I2C Bridging capabilities and is a superset of the CY3240 capabilities. Please note, the CY8CKIT-002 only contains the Miniprog3 and supporting cables.

In-circuit Programmer and debugger Cypress CY8CKIT-002

Cypress Semiconductor has completed a hardware update to the Miniprog3 to address hardware issues seen with programming, ESD, and power management. The Miniprog3 revision, either *A or *B, is indicated using sticker on the back of the programmer. The following are a list of updates made to the Miniprog3 *B programmer.

The Miniprog3 hardware has been updated to better improve power cycle programming for all PSoC devices. It was discovered that the Miniprog3 *A programmer revision did not correctly implement the power cycle programming methodology. Due to this issue the Miniprog3 *A programmer could not correctly support power cycle programming for PSoC 3 and PSoC 5 devices. This specifically impacts customers who do not route out the XRES line to the programming connector or disable the optional XRES line on certain devices. The *B revision of the Miniprog3 will support power cycle programming for all PSoC 3 and PSoC 5 devices.

There are known electrical risks to the Miniprog3 *A revision that have been addressed with the *B update. To address the electrical issues the Miniprog3 *B programmer has added ESD over-current protection to the USB lines and has added electrical protection to the 5 and 10-pin connectors in case of a reverse polarity condition.

The Miniprog3 *B programmer has been updated to improve the voltage detection capabilities. The Miniprog3 will measure the target voltage within an accuracy of 20 mV for a range of 1.8V – 5.0V.

The Miniprog3 *B programmer is supported on the latest release of PSoC Programmer.

CY8CKIT-002 Contents

cypress.com
 

Other Names:

CY8CKIT002, CY8CKIT 002

JLCPCP: 2USD 2Layer 5PCBs, 5USD 4Layer 5PCBs

You may have to register before you can post comments and get full access to forum.
User Name
Free Shipping for All PCB Assembly Order