Often you want to turn on and off power to a device with a single pushbutton switch. The circuit below performs this logic function with just a few parts and can operate from DC supplies between +3 V to about 15 V. It uses two inverters within a ...
Driving LEDs at a regulated current from low supply voltages can be difficult because minimal overhead voltage is available for control circuits. A current-mirror architecture is suitable but usually works only with ICs with well-matched ...
The basis for this Design Idea is a circuit that uses three resistors and a microcontroller-I/O pin to work as input high impedance or output to independently drive two LEDs ( Reference 1 ). The idea sounded good for this design, mainly because of ...
The purpose of this Design Idea was to improve reliability, add new features, and replace a latching power switch with a momentary one. The features are: The switch has foolproof protection against too frequent switching, which can be harmful for ...
You sometimes need an inexpensive VCO that can produce evenly spaced three-phase outputs over a wide frequency range. You could use tracking all-phase filters with only one oscillator, but this technique is difficult to implement and offers limited ...
In new mixed-voltage systems, it is often necessary to level-shift a control signal from a high level to a low level. An open-drain device, such as the 74LVC2G07 , easily performs this shift. However, when a bidirectional signal requires ...