All Sections Texas Instruments - 9

Manufacturer: "Texas Instruments"
Search results: 106,496 Output: 81-90
  1. Many applications require a sinusoidal reference voltage synchronized to the ac line voltage. You cannot derive such a reference voltage directly from the ac line because the waveform of the ac line is distorted because of nonlinear loads connected ...
    31-07-2023
  2. Whether you use them as indicators or to provide illumination, LEDs are hard to beat in efficiency, reliability, and cost. White LEDs are rapidly gaining popularity as sources of illumination, as in LCD backlights, but with forward voltages ...
    20-07-2023
  1. Circuits Texas Instruments OPA365 SN7407 TLV3501
    Introduction In some applications it is necessary to transmit square waves across a long cable. However, long cables typically have high capacitance, which can significantly affect the signal’s wave shape. As such, the signal’s ...
    10-07-2023
  2. Circuits Texas Instruments CD4053B TLV2374-Q1
    It’s just an unavoidable fact: electronic components’ parameters drift with temperature. Even the most stable voltage references, op amps, crystal oscillators, etc., have non-zero temperature coefficients. These effects can be mitigated ...
    04-07-2023
  3. If you need to quickly and inexpensively convert a binary number into a proportional analog voltage, one cool (and easily remoted) way to do it is: 1. Serialize the number into a bit stream with the LSB output first, 2. input the resulting stream ...
    29-06-2023
  4. Self-heated thermal airflow sensors are simple, cheap, rugged, and sensitive. However, they exhibit an airspeed to sensor temperature response ( King’s Law ) that is very nonlinear, as shown in Figure 1. Figure 1. The TO-92 junction ...
    21-06-2023
  5. The isolation amplifier circuit of Figure 1 is simple but accurate. With the values shown it converts 0 to 5 V DC or low frequency signals with unity gain, but you can adjust the gain by changing R4. Figure 1. The floating sigma-delta converter U1 ...
    15-06-2023
  6. When driving an H-bridge or a similar circuit, you usually must ensure that two or more transistors are not on at the same time. Eliminating multiple transistors from turning on reduces power consumption and lowers EMI (electromagnetic ...
    02-06-2023
  7. The circuits in Figures 1 and 2 shows a PWM (pulse-width-modulated) ramp generator that you can use in low-cost switch-mode dc/dc power supplies. Its supply voltage can range from 5 to 35 V dc, and you can set the output-ramp amplitude of 0.3 to 1 ...
    26-05-2023
  8. First and second amplifiers and range switch The schematic is shown in Figure 3. Figure 3. First and second amplifiers and range switch. The switching is arranged so that there are no unused resistors attached to the signal circuit; they are ...
    25-05-2023

Sort by: relevance / date

EMS supplier