Circuits & Schematics Microcontrollers Usage: pic - 8

Subsection: "Microcontrollers Usage"
  Including:
  AVR   Clock   PIC   Programmer
Search results: 132 Output: 71-80
  1. Keypads are a very commonly used input device in microcontroller-based systems. In a keypad, multiple switches are arranged in rows and columns so that they could be interfaced to a microcontroller with a minimum number of I/O pins. For example, a ...
    25-03-2011
  1. .. connected to the microcontroller with individual pull-up resistors on each input. In this project I used RB4 and RB5 on the PIC to connect the encoder; this has 2 advantages, firstly you can use the PORTB internal weak pull-up (which means you ...
    25-03-2011
  1. Part 1. Schematic Software The firmware does all the control and computation operation. In order to save the power, the sensor module is not activated continuously. Instead, it is turned on for 15 sec only once the start button is pressed. The ...
    14-03-2011
  2. .. the code. You simply need to compile the PICDEM FS USB projects which are included with the stack examples. Building the PIC DEM FS USB board The circuit schematics for the original board are available on-line from Microchip, they publish ...
    26-02-2011
  3. Introduction Heart rate measurement indicates the soundness of the human cardiovascular system. This project demonstrates a technique to measure the heart rate by sensing the change in blood volume in a finger artery while the heart is pumping the ...
    11-02-2011
  4. .. be turned off again. The following video shows how to do this. Software The firmware is developed using the MikroC Pro for PIC compiler. Downloads Source Code - download HEX file - download embedded-lab.com
    10-02-2011
  5. Part 1. Schematic and construction The firmware is completely written in C and can be downloaded from the downloads section below. The firmware is split into 4 parts: ADC Sampling The ADC sampling routine samples the voltage level on RA0 every 50 ...
    02-02-2011
  6. Ivailo Vasilev Brightness settings The user can select the brightness level in 8 steps or select an auto mode. To change the brightness from Settings menu, select Bright and press SET. The display will show the current bright level (from Bright 1 ...
    01-02-2011
  7. .. with a PIC18F458 and the 128MB Multimedia Memory Card, MMC. The solar radiation is measured by a calculator solar cell. The PIC chip interfaces the MMC using SPI mode. The interval between samples is set to one minute. The firmware detects the ...
    19-01-2011
  8. .. board): The picture shows a full-volume 5000Hz sine wave generated by a PC. If we were to feed this signal directly to the PIC we would only have a very small range of input voltage (0-0.5V) and also we would only be able to sample the ...
    18-01-2011

Sort by: relevance / date

Search "pic" on other search engines: Only-DataSheet.com Google
EMS supplier