Electronics ru
Advanced Search +

Datasheet Texas Instruments CC430F5133IRGZ

Datasheet Texas Instruments CC430F5133IRGZ

ManufacturerTexas Instruments
Part NumberCC430F5133IRGZ

16-Bit Ultra-Low-Power MCU, 8KB Flash, 2KB RAM, CC1101 Radio, AES-128, 12Bit ADC, USCI 48-VQFN -40 to 85


  • Download » Datasheet, PDF, 2.0 Mb, Revision: H, 09-06-2013, File uploaded 03-20-2018
    CC430F613x, CC430F612x, CC430F513x MSP430 SoC With RF Core datasheet
    Docket ↓
    ECCN 5E002 TSPA -Technology / Software Publicly Available CC430F6137, CC430F6135, CC430F6127, CC430F6126, CC430F6125
    CC430F5137, CC430F5135, CC430F5133 SLAS554H – MAY 2009 – REVISED SEPTEMBER 2013 MSP430™ SoC With RF Core
    Check for Samples: CC430F6137, CC430F6135, CC430F6127, CC430F6126, CC430F6125, CC430F5137, CC430F5135, CC430F5133 FEATURES 1 23 True System-on-Chip (SoC) for Low-Power
    Wireless Communication Applications
    Wide Supply Voltage Range:
    3.6 V Down to 1.8 V
    Ultralow-Power Consumption:
    – CPU Active Mode (AM): 160 µA/MHz
    – Standby Mode (LPM3 RTC Mode): 2.0 µA
    – Off Mode (LPM4 RAM Retention): 1.0 µA
    – Radio in RX: 15 mA, 250 kbps, 915 MHz
    MSP430 System and Peripherals
    – 16-Bit RISC Architecture, Extended
    Memory, up to 20-MHz System Clock
    – Wake Up From Standby Mode in Less
    Than 6 µs
    – Flexible Power-Management System With
    SVS and Brownout
    – Unified Clock System With FLL
    – 16-Bit Timer TA0, Timer_A With Five
    Capture/Compare Registers
    – 16-Bit Timer TA1, Timer_A With Three ...


Family: CC430F5133, CC430F5135, CC430F5137, CC430F6125, CC430F6126, CC430F6127, CC430F6135, CC430F6137


Lifecycle StatusActive (Recommended for new designs)
Manufacture's Sample AvailabilityNo


Package TypeRGZRGZ
Package QTY5252
Device MarkingCC430F5133
Width (mm)77
Length (mm)77
Thickness (mm).9.9
Pitch (mm).5.5
Max Height (mm)11
Mechanical DataDownload »Download »


ADCADC12 - 6ch
Additional FeaturesReal-Time Clock,Watchdog,Temp Sensor,Brown Out Reset
Antenna ConnectionDifferential
CPU CoreMSP430
CPU Processing Power Consumption160 uA/MHz
Data Rate (Max)500 kbps
Flash8 KB
Frequency20 MHz
Frequency Bands315,433,779,868,915,920 MHz
Key ApplicationsData logging, Remote monitoring systems, Wireless sensor networks
Max VCC3.6
Min VCC1.8
Non-volatile Memory8 KB
Operating Temperature Range-40 to 85 C
Package GroupVQFN
Package Size: mm2:W x L48VQFN: 49 mm2: 7 x 7(VQFN) PKG
RF standard supportedProprietary (Sub 1GHz)
RX Current (Lowest)15 mA
Standard versionN/A
Standby Current1 uA
Timers - 16-bit2
Wake-on radioYes
Wakeup time from standby240 us

Eco Plan


Design Kits & Evaluation Modules

  • Evaluation Modules & Boards: MSP-SA430-SUB1GHZ
    Sub-1 GHz RF Spectrum Analyzer Tool
    Lifecycle Status: Active (Recommended for new designs)
  • Evaluation Modules & Boards: EM430F5137RF900
    CC430F5137 Wireless Development Tool
    Lifecycle Status: Active (Recommended for new designs)

Application Notes

  • Download » Application Notes, PDF, 210 Kb, Revision: A, 07-10-2012
    CC430 Wake-On-Radio Functionality (Rev. A)
    The Wake-On-Radio (WOR) feature of the CC430 is a recommended method for conserving power in wireless systems in which the radio periodically wakes up from SLEEP mode and listens for incoming packets. This application note describes the theory, RF1A registers, and timing of the WOR feature. It also describes the special use case of the CC430F61xx and CC430F51xx devices. This application note concl
  • Download » Application Notes, PDF, 89 Kb, 03-10-2010
    AN088 -- SimpliciTI on the CC430 – Practical Modifications
  • Download » Application Notes, PDF, 966 Kb, 05-20-2011
    CC430-Based Wireless Mesh Network Mains Switch
    This application report describes a simple wireless mesh network running on a number of wireless power points. Each power point contains a timer switch and a power monitor. The mesh network is self learning. A data concentrator works through the various power points it discovers and forms a network. It can then program the on/off timing of the power point's switch and monitor its power consumption
  • Download » Application Notes, PDF, 117 Kb, Revision: C, 09-07-2012
    CC430 RF Examples (Rev. C)
    This application report describes the library components and implementation of the RF code examples for the CC430F61xx and CC430F51xx sub-1GHz system-on-chip (SoC) devices. The examples include support for packet-handling modes, including variable and fixed length filtering, as well as the asynchronous and synchronous modes of communication. The document also explains the key RF configuration regi
  • Download » Application Notes, PDF, 4.6 Mb, 07-05-2011
    Using a DC-DC Converter to Reduce Power (Current) Consumption In CC430 Systems
    This application report describes a method to reduce power consumption in CC430-based systems by using a step-down converter TPS62730.
  • Download » Application Notes, PDF, 983 Kb, Revision: A, 08-03-2011
    AN105 -- Using 1W RF3858 Front End with CC1101 Under FCC 15.247 (Rev. A)
  • Download » Application Notes, PDF, 371 Kb, 01-11-2011
    AN094 -- Using the CC1190 Front End with CC1101 under EN 300 220
  • Download » Application Notes, PDF, 139 Kb, Revision: A, 11-07-2011
    DN036 -- CC1101+CC1190 600 kbps Data Rate, +19 dBm Transmit (Rev. A)
  • Download » Application Notes, PDF, 359 Kb, Revision: A, 08-19-2009
    AN072 -- Using the TAI-SAW TA0801A SAW Filter and External PA (Rev. A)
  • Download » Application Notes, PDF, 223 Kb, Revision: B, 09-11-2009
    AN050 -- Using the CC1101 in the European 868MHz SRD band (Rev. B)
  • Download » Application Notes, PDF, 65 Kb, 01-25-2010
    DN508 -- Frequency Scanning using CC430Fx, CC110x, and CC111xFx
    The purpose of this design note is to show the necessary steps to successfully scan through a frequency band covering n numbers of channels, and find the strongest signal in the band.
  • Download » Application Notes, PDF, 96 Kb, Revision: C, 08-20-2009
    DN005 -- CC11xx Sensitivity versus Frequency Offset and Crystal Accuracy (Rev. C)
  • Download » Application Notes, PDF, 532 Kb, Revision: E, 03-08-2012
    DN022 -- CC110x CC111x OOK ASK Register Settings (Rev. E)
  • Download » Application Notes, PDF, 112 Kb, 08-25-2010
    DN032 -- Options for Cost Optimized CC11xx Matching
  • Download » Application Notes, PDF, 832 Kb, Revision: B, 08-20-2009
    DN016 -- Compact Antenna Solution for 868/915 MHz (Rev. B)
  • Download » Application Notes, PDF, 327 Kb, Revision: B, 09-18-2009
    DN019 -- Powering Low-Power RF Products (Rev. B)
  • Download » Application Notes, PDF, 264 Kb, 01-28-2010
    DN507 -- FEC Decoding
    The purpose of this design note is to show how the FEC decoding implemented in HW on the CC1100, CC1100E, CC1101, CC1110Fx, CC1111Fx, CC1150, CC2500, CC2510Fx, CC2511Fx, and CC2550 can be implemented in SW. This is in particular very important for the CC430Fx device, which has the same radio as the CC1101 and CC1110/11Fx but without HW FEC included.
  • Download » Application Notes, PDF, 1.0 Mb, Revision: E, 02-22-2013
    DN024 -- 868 MHz, 915 MHz and 955 MHz Monopole PCB Antenna (Rev. E)
  • Download » Application Notes, PDF, 55 Kb, Revision: D, 10-27-2009
    DN502 -- CRC Implementation (Rev. D)
  • Download » Application Notes, PDF, 260 Kb, 02-01-2006
    AN001 -- SRD regulations for license free transceiver operation
  • Download » Application Notes, PDF, 685 Kb, Revision: A, 09-14-2010
    DN033 - Mitsubishi Ceramic Antenna for 868 MHz, 915 MHz & 955 (Rev. A)
  • Download » Application Notes, PDF, 369 Kb, Revision: C, 08-30-2011
    DN023 -- 868 MHz, 915 MHz and 955 MHz Inverted F Antenna (Rev. C)
  • Download » Application Notes, PDF, 364 Kb, 12-20-2006
    DN002 -- Practical Sensitivity Testing
  • Download » Application Notes, PDF, 358 Kb, 02-01-2006
    AN003 -- SRD Antennas
  • Download » Application Notes, PDF, 126 Kb, Revision: T, 10-12-2011
    DN000 - Design Note Overview (Rev. T)
  • Download » Application Notes, PDF, 2.3 Mb, 08-26-2010
    DN031 -- CC-Antenna-DK Documentation and Antenna Measurements Summary
    DN031 -- Design Notes
  • Download » Application Notes, PDF, 1.8 Mb, Revision: B, 10-06-2010
    AN058 -- Antenna Selection Guide (Rev. B)
  • Download » Application Notes, PDF, 69 Kb, Revision: A, 03-11-2015
    Using the USCI I2C Master (Rev. A)
    This document describes how to use the I2C master function set for MSP430™ devices with the USCI module. These functions can be used by MSP430 master devices to ensure proper initialization of the USCI module and provide I2C transmit and receive functionality. A similar version with DMA support has also been included. The USCI I2C master function set only supports single-master transmitter or rece
  • Download » Application Notes, PDF, 138 Kb, Revision: A, 02-12-2013
    DN035 -- Antenna Quick Guide (Rev. A)
  • Download » Application Notes, PDF, 475 Kb, 10-05-2012
    Design Considerations When Using the MSP430 Graphics Library
    LCDs are a growing commodity in todays market with products as diverse as children's toys to medical devices. Modern LCDs, along with the graphics displayed on them, are growing in complexity. A graphics library can simplify and accelerate development while creating the desired user experience. TI provides the MSP430 Graphics Library for use in developing products with the MSP430™ MCU. This

Moldel Line

Series: CC430F5133 (3)

Manufacturer's Classification

  • Semiconductors > Microcontrollers (MCU) > Other Microcontrollers > CC430
Slices ↓
Radiolocman facebook Radiolocman twitter Radiolocman google plus