Starter Kit Microsemi SF2-STARTER-KIT-ES-2

ManufacturerMicrosemi
Part NumberSF2-STARTER-KIT-ES-2

Microsemi's SmartFusion2 Starter Kit (SF2-STARTER-KIT-ES-2) provides designers with access to SmartFusion2 system-on-chip(SoC) FPGAs, which integrate inherently reliable flash-based FPGA fabric, a 166 MHz ARM Cortex-M3 processor, advanced security processing accelerators, DSP blocks, SRAM, eNVM and industry required high-performance communication interfaces all on a single chip.

Prices

Detailed Description

Starter Kit Microsemi SF2-STARTER-KIT-ES-2

The SmartFusion2 starter kit supports industry-standard interfaces including Ethernet, USB, SPI, I2C and UART and includes a comprehensive breadboard to support unique design requirements.

The kit can be used with Microsemi's Libero SoC v11.0 software, which includes a free Libero Gold license and comes preloaded with a uClinux demo. Emcraft Systems' Linux-based development environment is also supported. The SmartFusion2 device is available on an Emcraft Systems miniature (34mm x 59mm) mezzanine form factor system-on-module (M2S-SOM), which connects to the SOM-BSB-EXT baseboard. The kit is USB powered and includes FlashPro4 programming.
The SF2-STARTER-KIT-ES is RoHS compliant

SmartFusion2 Starter Kit Hardware Feature Overview

  • SmartFusion2 SoC FPGA in the FG896 package (M2S050T-FG896ES)
  • JTAG interface, for programming of the SmartFusion2 device
  • 10/100 Ethernet interface and RJ-45 connector
  • USB OTG interface and mini-USB connector
  • USB based Wi-Fi Module
  • 64MB LPDDR, 16MB SPI flash
  • User push-button connected to GPIO on the SOM
  • Two user-controlled LEDs connected to GPIO on the SOM
  • Breadboard area available for GPIO or FPGA I/O connection
  • Power good LED indicating presence of the +3.3 V SOM power
  • Reset push button, Reset-out LED
  • On-module clocks
  • Watchdog Timer (WDT)
  • Serial console interface at UART CMOS levels
  • Low power mode with fast wake-up times
  • Depending on the design, can provide necessary power supply voltages (+5 V, +3.3 V, +1.5 V for power-optimized SOM operation) from external sources through dedicated pads on the breadboard.

Quantity

  • 1 M2S-SOM SmartFusion2 system-on-module with M2S050-FG896
  • 1 SOM-BSB-EXT SmartFusion2 system-on-module baseboard
  • 1 FlashPro4 JTAG programmer for programming and debugging of SmartFusion2
  • 1 USB 2.0 A male to mini-B Y-cable for UART/power interface (up to 1A) to PC
  • 1 USB 2.0 A male to mini-B cable for connection of SmartFusion2 to PC in USB device ("gadget") role
  • 1 Mini-B to USB 2.0 A female cable for connection of USB devices to SmartFusion2
  • 1 Ethernet cable
  • 1 USB WiFi module
  • 1 Leather case

Note: This Kit also comes with a free Libero Gold software License.

microsemi.com

Other Names:

SF2STARTERKITES2, SF2 STARTER KIT ES 2

You may have to register before you can post comments and get full access to forum.
EMS supplier