Evaluation Kit Atmel ATMEGA168PB-XMINI


The Atmel ATmega168PB Xplained Mini evaluation kit is a hardware platform for evaluating the Atmel ATmega168PB microcontroller.


China PCB Prototype and Fabrication Manufacturer

Detailed Description

The evaluation kit comes with a fully-integrated debugger that provides seamless integration with Atmel Studio 6.2 or later. The kit provides access to the features of the ATmega168PB enabling easy integration of the device in a custom design.

Evaluation Kit Atmel ATMEGA168PB-XMINI

Key Features

  • ATmega168PB MCU Installed:
    • Advanced RISC Architecture
    • 131 Powerful Instructions – Most Single Clock Cycle Execution
    • 32 x 8 General Purpose Working Registers
    • Up to 20 MIPS Throughput at 20MHz
    • 16 KBytes of In-System Self-Programmable Flash program memory
    • 512 Bytes EEPROM
    • 1 KBytes Internal SRAM
    • Atmel QTouch library support
    • Capacitive touch buttons, sliders and wheels
      • QTouch and QMatrix acquisition
      • Up to 64 sense channels
    • Peripheral Features
      • Two 8-bit Timer/Counters (TC) with Separate Prescaler and Compare Mode
      • 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture Mode
      • Real Time Counter (RTC) with Separate Oscillator
      • Six Pulse Width Modulation (PWM) channels
      • 8-channel 10-bit ADC with temperature measurement
      • Programmable Serial USART with start-of-frame detection
      • Master/Slave SPI Serial Interface
      • Byte-oriented Two-Wire Serial Interface (Phillips I2C compatible)
      • Programmable Watchdog Timer (WDT) with separate on-chip oscillator
      • On-chip Analog Comparator
      • Internal calibrated oscillator
      • External and internal interrupt sources
      • Six Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, Standby, and Extended Standby
    • Unique Device ID
    • 27 Programmable I/O Lines
    • 32-lead TQFP and 32-pad VFQFN
    • Operating Voltage: 1.8 - 5.5V
  • On-board debugger with full source-level debugging support in Atmel Studio
  • Auto-ID for board identification in Atmel Studio 6.2
  • Access to all signals on target MCU
  • One green status LED
  • One mechanical user pushbutton
  • Virtual COM port (CDC)
  • 16MHz target clk
  • USB-powered
  • Arduino shield-compatible foot prints
  • Target SPI bus header foot print
  • Xplained Pro extension headers can easily be strapped in
  • Supported with application examples published on Atmel Spaces

ATMEGA168PB-XMINI Schematic Diagram

Main Features of Kit or Board

Base componentAtmel
Category, bit8-bit
Supported familiesAVR8-bit
Board peripherals
  • I/O pins
  • I2C interface
  • SPI
  • TWI
  • USB
  • analog inputs
  • temperature sensor
  • user buttons
  • user LEDs
  • sense
  • Expansion Board

Other Names:


You may have to register before you can post comments and get full access to forum.
User Name