Debugger/Programmer Module FTDI VNC2-Debug-module

The VNC2 debugger and programmer module consists of a miniature board with a USB miniB connector, which provides USB connectivity to Vinculum-II IDE development tools running on a PC.

Detailed Description

This module can be used to program and debug firmware running on the VNC2 device.

FTDI: VNC2-Debug-module

Features

  • The VNC2 debug module incorporates the following features:
  • One USB ‘miniB’ type socket to connect with a PC.
  • Onboard FTDI FT232R which provides conversion from USB to serial interface for VNC2 debug port.
  • Low USB bandwidth consumption.
  • USB2.0 Full Speed compatible.
  • UHCI/OHCI/EHCI host controller compatible.
  • 5V Power output to V2DIP-x module (if needed).
  • USB powered.
  • Programming and debugging for VNC2 IC designs.
  • Power and traffic indicator LEDs
  • 6 way, keyed connector to support FTDI’s range of V2DIPx-x development modules.
  • VNC2 debug module is a Pb-free, RoHS complaint development module.
  • -40℃ to +85℃ operating temperature range.

User manual and Schematic diagram

ftdichip.com

Other Names:

VNC2Debugmodule, VNC2 Debug module

You may have to register before you can post comments and get full access to forum.
EMS supplier