Circuits & Schematics: Wire - 5
Search for: "Wire"
Search results: 261 Output: 41-50
- .. as well for now. The coils The RM10 core and the two 12 uH coils weren't available either so I had to buy some cobber wire and some ferrite cores and do the coils myself. I got a spool of 0.75 mm insulated cobberwire, a couple ferrite ...31-10-2007
- .. sink on triac. The rest of parts are defined in schematic. You must be careful when you connect IrLightDimmer to electrical wire, so you must break fuse switches of your lights. All connections must be like in my schematic, otherwise device ...02-11-2007
- .. hardware shops: Sctoch double sided tape #668 from 3M around 2cm wide, vinyl tape to cover the solder points, around 1m two wire cable (we used the multi stranded type around 1mm in diameter each to have a soft feeling) and Textile glue. ...16-11-2007
- .. Salvaged Plastic Project Box Clear Vinyl Sheet (craft store; 50¢) Large Eyelet Kit (craft store; $2.45) Clips Wire NOTE: There are four distinct subassemblies which constitute our eBag: (1) modified messenger bag, (2) ...16-11-2007
- .. just have to supply the required voltage to make them work. I simply fastened the solenoid to the door knob with a metal wire. When the solenoid is switched on, its linear motion twists the door knob and opens the door. Positioning the ...18-11-2007
- .. difficult to build but the pen may be built in any number of ways as long as a couple of critical requirements are met. The wire probe sticking into the ion chamber must not touch anything that is ever-so-slightly conductive, not even most ...29-11-2007
- .. proven to work) cross-point screwdriver soldering iron tin-lead solder rosin or flux sharp knife 2 cm of thin insulated wire (2 pcs) (only if necessary) 1. Disassemble the mouse. Now you can see the three switches that make more than 90 % ...08-12-2007
- .. the one on the left should have its positive side up. You can't see from this image, but you also need to solder a piece of wire between the two battery contacts on the opposite side of the board as well. The PIC is soldered to the PCB on the ...11-12-2007
- .. homemade speaker using a plastic cup, business card, wire, magnet and some Lego blocks. I built this speaker from scratch; I was surprised of the quality of the sound. I ...24-12-2007
- .. the battery's charge capability, you can send the data to a host processor or another destination through a single-wire interface, SPI, I2C, CAN (controller-area-network), or another industry-standard method. To maximize battery ...21-01-2008
Sort by: relevance / date
