Circuits & Schematics: Wire - 3
Search for: "Wire"
Search results: 261 Output: 21-30
- .. industry, in which the goal is to produce cars with simpler, lighter wiring looms, any interface that uses just one wire instead of two offers a distinct advantage. The circuit in Figure 1 implements a bidirectional link using a ...23-04-2024
- .. can be used for AM, FM, and Shortwave(SW). On the shortwave band this active antenna is comparable to a 20 to 30 foot wire antenna. It is further more designed to be used on receivers that use untuned wire antennas, such as inexpensive ...10-02-2007
- .. is using an ATX power supply, with Sparkfun's adapter board(you need this too) and this adapter. You would solder the red wire to 5v on the adapter board, and the black wire to ground. Please note that you must also connect PS_ON to ground. ...01-11-2011
- .. down, or may overheat and burn up (all the magic blue smoke leaks out). Methods for making 4 ohm speaker to appear as 8 ohm Wire a 4-ohm power resistor (10-20 watt) in series with each 4-ohm speaker. This makes the system to be appear as 8 ...04-09-2005
- .. 1. Pushing the on switch S 1 or S 2 for approximately 1 sec inserts the 12 V zener diodes D 1 or D 2 in series with the hot wire of the power line. During the push, the polarity-dependent conduction of the zener diodes creates a small ...03-11-2022
- .. inch at the bottom, 1.5 inches at the top, and 3 inches tall. Each coil is wound with 59 turns using two strands of #14 AWG wire in hand. This is definitely an improvement over the older 17 foot wind turbine we built. This stator is just like ...01-01-2011
- .. NTC 10k or similar 9 or 25 pin female connector Built device NTC thermistor is connected to other end of black-red wire. Schematics Description Let's say DTR and TXD are zero at the beginning. Nothing is going on. Then we set DTR to ...17-03-2008
- .. you need a $5.29 snap-on EMI suppressor from radio shack, part number 273-105, and you need some 18-20 gauge magnet wire (enamel-insulated copper wire). The magnet wire at radio shack is too small, you'll have to look elsewhere. ...16-10-2007
- .. an outdoor thermosensor and a main board. Construction is as simple as it can be - the AVR reads the temperature from the 1-Wire thermometer and sends necessary data to the display. The display is made from two dual 7-segment LED displays. I ...18-10-2007
- .. 1 blue, 1 yellow, 1 red, and 1 white. In a 4 phase unipolar motor There are 2 coils which are center tapped and have a wire for each of phases. If the wire colours are random or if there were only 5 wires, then you would have to use an ...20-10-2007
Sort by: relevance / date
