Circuits & Schematics: metal - 2
Search for: "metal"
Search results: 116 Output: 11-20
- .. and you just have to supply the required voltage to make them work. I simply fastened the solenoid to the door knob with a metal wire. When the solenoid is switched on, its linear motion twists the door knob and opens the door. Positioning ...18-11-2007
- .. to the transformer (these notes will help you rebuild your doorbell, if you long for a dingdong, again). Remove the metal plates, electromagnetic coils, and movable plungers from the doorbell. Connect the MP3 speaker and squeeze both ...20-11-2007
- .. the collector circuit enabling the 555 osillator to sound. An On/Off switch is provided and remember to use a non-reactive metal for the probe contacts. Gold or silver plated contacts from an old relay may be used, however a cheap ...27-10-2007
- .. not touch anything that is ever-so-slightly conductive, not even most glasses and the electronics must be surrounded by a metal package to shield it from stray electric fields. Because the ion chamber is so small, the LED will only light ...29-11-2007
- .. the R3/R4 ratio is as close as possible to 2:1 and the offset voltages of IC2 and IC4 are as low as possible. R1 and R2 are metal film 1% resistors. C1 is a 2% capacitor with low dielectric absorption. Switch transistor Q1 should have small ...07-05-2020
- .. card and not higher than one inch. I used Lego bricks because I had some handy. Wood may work better. Try not to use any metal that can be attracted by the magnet. Put some glue on the magnet when it is inside the cylinder. On this step, ...24-12-2007
- .. LEDs, resistors and some wire plus good set of different tools and couple of straight hands ;-) LCD consists of PCB, metal frame and liquid crystal glass assembly. Back side of LCD glass is covered with very thin reflective film, ...22-01-2008
- .. a 3 V coin cell battery a 100 Ohm resistor (anything close to 100 will work) a momentary or push button switch. thin sheet metal plexiglass tools: hot glue gun metal shears sharpie saw soldering iron Cut out 6 squares of equal size from the ...28-02-2008
- .. use glue if needed. Remember also in designing your mount -- the magnetic field from the magnet disc should be away from metal cage bars or other metal parts.....it will be attracted to these metal parts and will be slowed down ...29-02-2008
- .. 2-volts across it; and 1-amp flowing through it. So it should never need to dissipate more than ( 2 x 1 = 2-watts ). The metal part of the regulator body is connected to pin 2. Therefore, the heatsink will be at the same potential as pin ...24-03-2008
Sort by: relevance / date
