Circuits & Schematics: metal
Search for: "metal"
Search results: 115 Output: 1-10
- .. Collinson A single chip metal detecor with a range of a few inches. This is useful for decting nails or screws in walls and floors, or for ...27-10-2007
- .. and cost effective for people who already have 24, or 48V renewable energy systems in place. Pictured above are most of the metal parts with the exception of the tail boom, tail vane bracket and the piece of pipe that fits between the yaw ...09-11-2010
- .. that can solve a difficult sensing problem in a surprisingly simple manner. For example, it can be used to turn a liquid-metal thermometer into the sensing element of a thermostat. Such thermometers are available with maximum temperatures ...23-03-2011
- .. since these components can add distortion. NP0 and silver-mica type dielectric capacitors have excellent linearity, and metal-film surface-mount resistors are much less susceptible than carbon surface-mount resistors to generating ...12-07-2020
- .. a 4538 single-chip, dual monostable multivibrator. Depending on the speed required for the application, the IC could be a metal-gate device, a 74HC, or a 74HCT type. Figure 1. The direction discriminator circuit is based on a dual ...30-12-2019
- .. and him replace with proportional value constant resistance. The Rectifier Bridge BR1 should be placed in some point of metal box so that it's frozen. On the contrary the IC1-2-3, that good are is TO-3 case, should be placed in a ...10-04-2005
- .. leads terminated with a gold-plated phosphorus-bronze pin can serve as a low-leakage switch. You can find gold-plated metal pieces in any type of high-quality connectors. Also, you can clip the DUT or CUT between two gold-plated clips ...28-07-2020
- .. between the two junctions and well proportional to the temperature. There are some type of combination of materials (pure metal or alloy) as industry standard for temperature sensor. The K-type (chromel - alumel) thermocouple is the ...26-11-2012
- .. , part of the passive dropper, limits the current drawn from the power line, as the following equation shows: A 47 Ω metal-oxide resistor, R 1 , acts as an inrush-current limiter. Because the LEDs require a lot of energy, it’s ...26-07-2020
- .. tabs of the transistor and diode to be shorted together.. In other words, you can't simply bolt them both to a single, metal heatsink. In this version, I bolted the transistor to the heatsink, as it is the major heat-generator, and ...16-10-2007
Sort by: relevance / date
