Circuits & Schematics: www.aaroncake.net - 3
Search for: "www.aaroncake.net"
- .. amp then sums a scaled version of the R S1 sampled voltage with the regulator output V1 to produce corrected feedback and net load power V OUT that is constant and independent of load current. Figure 2. This variation of the circuit provides ...26-12-2021
- .. three ICs connect. The AD8250 has a typical bandwidth of 3.8 MHz and a guaranteed bandwidth of 3 MHz at a gain of 10. The net result is that the bandwidth of the amplifier is 1.9 MHz at a gain of 1000, which is more than six times that of ...27-10-2020
- .. Using a USB isolator between the Analyzer and your PC is not a bad idea! Windows users may need to install a driver: http://www.wch.cn/download/CH341SER_ZIP.html. This is not necessary for linux users. You need a UPDI programmer for uploading ...12-08-2020
- .. at either A or B forms the emitter current and is of more concern with regard to the limited 1-mA sink of the CMOS. With a net 1-mA current and approximately 250 uA remaining for the output load, you must choose a 6.8-kΩ resistor (0.75 ...17-03-2020
- .. the complexity of bidirectional drive. It works by exploiting a little-known quirk of all TECs: the inherent reversal of net heat flow at unconventionally high levels of drive current. Figure 2. This circuit puts unipolar drive in a ...03-12-2019
- .. log-ratio calculation by D3, D4, and A2 taken from reference optos O3 and O4, controlled by feedback amplifier A3. The net result is that, in nulling A2’s output, A3 implicitly calculates a drive signal for O3/O4 that accurately and ...20-10-2019
- .. signal paths present 5.5-kΩ impedances to each of the A and B amplifier sections' inputs. By inspection, the net 5.5-kΩ impedance from Section B's output to C 1 comprises the Thevenin-equivalent impedance of resistors ...03-09-2019
- .. behind the circuit in Figure 1 is to check the influence of a dc bias voltage on the frequency of a simple oscillator. The net result is a low-frequency VCO with a relatively large voltage-gain figure, which depends largely on the type of ...29-01-2019
- .. Q 1 , the 2N2222 transistor. The configuration of the transistor causes a V BE drop of approximately 0.7 V, resulting in a net voltage of 5 V for the next stage. The purpose of the transistor is to provide additional current to the LM2682 ...17-04-2018
- .. a cascade of the autozeroed AD8231 instrumentation amp, IC 1 , with a preset voltage gain of eight, IC 2 , and IC 3 . The net result is that the input-voltage offset of IC 2 causes an RTI (referred-to-input) voltage offset, which decreases ...08-02-2018
Sort by: relevance / date
