.. signal advances both the wiper and the counter. The pin of the DPP responds to negative-edge triggering, and the clock input of the counter responds to positive-edge triggering. If the signal driving the line is a pulse (a common ...
.. was purely analog and had no “10-MHz reference input” on the back to allow it to be synchronized with the ADC clock. The result is substantial spectral leakage in the FFT, so that it looks more like a circus tent than a single ...
.. noise back into the signals of interest. The circuit in Figure 1 is a scalable one-of-N latch that has the advantages of no clock and no capacitors, and it has an intrinsic active-channel indication. Figure 1. This one-of-N latching circuit ...
.. Incremental encoders normally provide two output signals, usually named Channel A and Channel B. These signals deliver both clock information, depending on resolution, and rotating speed. They differ only in phase margin (for example, 90 for ...
.. of working with that DI , it turned out that the output port has three lines - the Ground( GRND ), the Data ( DT ) and the Clock line ( CLK ). Signals shapes of these lines are shown in Figures 3, 4, and 5. Figure 3. One complete DI data ...
.. circuit was developed for a portable instrument using a 28-pin PIC MCU from Microchip Technology running an RTC (real time clock), EEPROM, and COG (chip on glass) LCD on the I 2 C bus, and a digital pot and microSD card on the SPI bus. The ...
.. control. Stepper-motor controllers can be simple (Figure 1), but they require a variable-frequency square wave for the clock input. The AD9833 low-power DDS (direct-digital-synthesis) IC with an on-chip, 10-bit DAC is ideal for this ...
.. microcontroller are in C and use the open-source AVR GCC compiler. The AVR ATtiny13 microcontroller operates at an internal clock frequency of 9.6 MHz without an internal-clock-frequency divider, so the PWM frequency is 9.6 MHz/256 = 37.5 ...
.. and operating frequency are resistor programmable and the operating frequency can be set to synchronize to an external clock. The LTM8074 also features programmable soft-start, output voltage tracking, power good indicator and enable ...