Hackster.io With a code size of 1 KB on an ATtiny13A MCU, this tiny module measures voltages up to 22 volts and current up to 5 amps. There are a lot of so-called USB doctor modules which are used for monitoring currents flowing through a USB ...
.. are shown in Figures 6,7,8. PCB shown in the Figure 9. Figure 6. Analog part of the project. Figure 7. Microprocessor Arduino Nano. Figure 8. Project Power Supply. Figure 9. Project PCB (top layer is green, bottom is red). Gerber ...
.. Fässler soldernerd.com Some of you may have seen my arduino-based inductance meter in the article [1]. The arduino-based meter works well and made a great ...
.. Radiolocman has published a description of two devices for for automatic lighting of the working area in the kitchen: Arduino version and NodeMCU version . The latter, despite several disadvantages, which I will report at the end of ...
.. using this simple capacitor-network circuit and software, designs using the Arduino Uno need only two I/O pins to read a hex-switch decoder, leaving the remaining pins for other functions. A ...
.. information Schematic diagram Printed Circuit Board (PCB) Arduino Sketch Highlights Conclusion Downloads References General information The second version of the controller ...
.. U3A, which strobes the sample-and-hold amplifiers, U4. Figure 2. The held voltages RH, GH, and BH are then converted by the Arduino Nano for further processing. Analog-to-digital conversion could be accomplished by the µC without U4, ...
.. in the room (and its sudden change) and the presence of human movement. The first version of the device is made on the Arduino Nano, it operates fully automatically and does not require any action from the user (Figure 2). The second ...
.. four switches and two LEDs, or five LEDs and one switch. It works well with Atmel ATmega microcontrollers including the Arduino, and could be of particular interest for any eight-pin devices, or when you’ve simply run out of I/O. ...